The Use of Potassium Permanganate in Fish Ponds
Posted by Unknown in Chemical, Fish Farming on Tuesday, 29 January 2013
Potassium
permanganate, KMnO4 , is a chemical oxidizing agent that will react
with any organic matter in a pond including algae, bacteria, fish,
particulate and dissolved organic, and organic bottom sediments. It has
been used in fish ponds to treat common fish pathogens such as gill
parasites and external bacterial and fungal infections. Contrary to some
reports, potassium permanganate does not add significant amounts of
oxygen to water and can actually decrease dissolved oxygen
concentrations by killing algae that produce much of the oxygen in
ponds.
Treatment Rate
Common
treatment rates are 2 parts per million (ppm) or milligrams per liter
(mg/L) for an indefinite pond application or 10 mg/L for a 10-minute
tank treatment. Actual treatment rates in ponds will vary depending on
the amount of organic matter, or organic load, in the water. As with any
chemical treatment, it is crucial to accurately estimate the volume of
water that is to be treated.
How to Estimate Water Volume
Potassium
permanganate is an expensive treatment. Therefore, it is important to
properly estimate water volume to achieve both a cost-effective and
biologically effective treatment. Underestimating water volume will
result in an insufficient concentration of chemical, and retreatment
would be necessary. Overestimating water volume can result in a
greater-than-desired concentration of chemical, and may injure or even
kill fish. Pond volume is measured in acre-feet (surface acreage
multiplied by the average water depth in feet). One acre-foot is equal
to one surface acre with a depth of one foot.
Estimating
pond volume can be difficult when a pond has an irregular shape and
varying water depth. The surface area of a square or rectangular pond
can be easily estimated by multiplying the pond length by the pond
width. Your local Soil Conservation Service or County Extension Service
Office can provide assistance in determining pond acreage for
irregularly- shaped ponds.
The
average water depth for ponds with a sloped and flat bottom can be
determined by averaging the shallowest and deepest water depths. For
example, a pond with a sloping flat bottom that has a maximum depth of
six feet and a minimum depth of four feet would have an average depth of
five feet. Determining the average depth for ponds with uneven bottoms
and widely varying depths requires measurement of water depth at
multiple locations in the pond using a simple grid or zig-zag sampling
approach, in which all areas of the pond are measured.
How to Calculate Amount of Chemical Required
An
important factor to remember is that 1 ppm (or 1 mg/L) is equal to 2.7
pounds of dry chemical per acre-foot of water. A sample calculation to
determine the amount of potassium permanganate required to treat a pond
at a 2 mg/L concentration is as follows:
Example:
You have estimated a pond to be 5 surface acres, and the pond has an average depth of 5 feet.
- 5 acres × 5 foot average depth = 25 acre-feet of water.
- 25 acre-feet × 2.7 lbs/acre-foot = 67.5 lbs of potassium permanganate to obtain a concentration of 1 mg/L in the pond.
- 67.5 lbs of potassium permanganate × 2 = 135 lbs of potassium permanganate to obtain a concentration of 2 mg/L in the pond.
A
2 mg/L treatment is usually effective for ponds with relatively clear
water. Potassium permanganate reacts with organic matter and becomes
neutralized and unavailable to treat the target parasite. The greater
the amount of organic matter in a pond, the more potassium permanganate
required to achieve the desired chemical concentration. Therefore, a
pond with moderate to heavy algal blooms will require a higher treatment
rate to neutralize the organic matter in the pond and still achieve the
desired concentration of 2 mg/L.
One
popular method of treatment is to begin with an application of 2 mg/L
potassium permanganate. If the pond remains pink to purple in color for
8--12 hours, then an effective treatment is assumed to have occurred,
and no additional chemical is required. However, if within a 12-hour
period, the pond turns brown, then an additional 1--2 mg/L treatment is
required, depending on how quickly the pond turned brown. It is
recommended that treatment begin in the morning so that the pond can be
watched for the next 8- to 12-hour period, and any color change can be
easily detected.
How to Determine Permanganate Demand
Another
method to estimate the amount of potassium permanganate required for
effective treatment is to determine the potassium permanganate demand or
amount of chemical required to react with all the organic matter in a
water sample. This procedure measures the 15-minute demand. This value
is then multiplied by 2 to give the recommended treatment rate. The
15-minute demand is determined as follows:
- Prepare a 1,000 mg/L stock solution by adding 1,000 milligrams or 1 gram of potassium permanganate to 1 liter of distilled water and mix thoroughly.
- Collect five 1-liter samples of the pond water.
- Prepare a series of test treatments. Add 2, 4, 6, 8, and 10 milliliters (mL) of the stock solution (prepared in Step 1) into the five 1-liter samples. Mix thoroughly.
- Wait 15 minutes.
- The test treatment that has the slightest faint pink color after 15 minutes is the correct 15-minute potassium permanganate demand. If there is a question as to which rate has a faint pink color, choose the lower treatment rate.
- Multiply the 15-minute demand treatment by 2 to get the proper treatment rate for the pond.
Example:
A
series of 1-liter pond water samples was treated with potassium
permanganate stock solution. After 15 minutes, the 2 mg/L treatment
turned brown, but the 4 mg/L treatment still had a faint pink color. The
4 mg/L treatment is therefore the 15-minute demand. Multiplying the 4
mg/L demand treatment by 2 gives a recommended pond treatment rate of 8
mg/L.
How to Apply Chemical
Potassium
permanganate is commercially available in crystal or powder form. it
should be mixed with water before use, and then applied evenly over the
entire pond surface to ensure an effective treatment. For small ponds
(less than one acre), application of the chemical can be achieved by
first adding a small portion of the total amount of chemical required
for treatment to water in a five-gallon plastic bucket, and then
broadcasting this solution over the surface of the pond while walking
around the pond. This process is repeated until all of the required
chemical is added to the pond. This method works well when the chemical
can be dispersed evenly over the entire surface area of a pond from the
shore. In larger ponds (larger than one acre), a boat equipped with a
large take or container and motor is recommended for distributing the
chemical. The chemical mixture can be applied by means of a submersible
pump or gravity fed from the container into the prop wash of the boat
motor. Uniform application can be achieved by driving the boar over the
entire pond surface.
Precautions When Using Potassium Permanganate
A few helpful reminders and precautions before using potassium permanganate include:
- Be sure you have a problem that warrants treatment. Potassium permanganate is expensive. For example, it cost approximately $80 to treat a one-acre pond, with an average depth of 5 feet, at a 4 mg/L concentration. Have your fish properly diagnosed and carefully consider the cost.
- Potassium permanganate is a strong oxidizer and can burn skin, eyes, and other body parts. It will stain you and everything it touches brown. Always use safety protective gear including rubber gloves, goggles and old clothes. A dust mask is advisable to prevent irritation to your respiratory tract.
- Be sure to estimate water volume accurately, and disperse the chemical evenly over the entire pond to prevent hot spots, areas of the pond with excessive amounts of chemical.
- Potassium permanganate can kill algae. Low oxygen conditions can occur following treatment. Be prepared to aerate after treatment.
- Frequent treatment can harm fish. Wait at least four days before repeating treatment. If fish do not respond to treatment, reevaluate them to confirm the diagnosis.
Author : Andrew M. Lazur - Institute of Food and Agricultural Sciences, University of Florida
Footnotes
- This document is FA23, one of a series of the Fisheries and Aquatic Sciences Department, Florida Cooperative Extension Service, Institute of Food and Agricultural Sciences, University of Florida. Original publication date June, 1992. Reviewed July, 2002. Visit the EDIS Web Site.
- Andrew M. Lazur, assistant professor, Department of Fisheries and Aquaculture, Cooperative Extension Service, Institute of Food and Agricultural Sciences, University of Florida, Gainesville, 32611.
